TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 254 of 750

TM 5-5420-228-24

PUMP DRIVE SHAFT UNIVERSAL JOINT REPLACEMENT AND REPAIR (Sheet 5 of 5)

INSTALLATION:

1.

Manually install driveshaft assembly (H), onto power take off shaft (K).

2.

Lift driveshaft assembly (H) onto yoke (D).

3.

Install two clamps (C) and two washers (B) two screws (A) tighten with ½ inch wrench.

WARNING

Ensure drive shaft collar clamp is in place prior to operation.

Failure to do so may

result in damage to equipment or personal injury or death.

4.

After driveshaft assembly (H) is installed, adjust collar clamp (F) to completely engage both ends of

collapsible shaft into pump and P.T.O. shafts (K,L). Collapse 1/8 inch, tighten screw (E) so that no

further collapsing of shaft is possible.

5.

Lubricate drive shaft (LO-12).

6.

Install universal joint cover (page 3-61).

End of Task

Change 3

3-64.5/(3-64.6 blank)

C

D

B

A

G

F

H

E

J

L

K