TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 556 of 750

TM 5-5420-228-24

HOLDDOWN CYLINDER HOSE GUARD REPLACEMENT (Sheet 1 of 2)

TOOLS:

7/8 in. open end wrench

1-1/2 in. socket with 3/4 in. drive

Ratchet with 3/4 in. drive

SUPPLIES:

Rags (Item 12, Appendix D)

Protective caps and plugs

Pipe tape (Item 19, Appendix D)

Pencil (Item 22, Appendix D)

Masking tape (Item 18, Appendix D)

Lockwashers (2 required)

REFERENCE:

TM 5-5420-202-10

PRELIMINARY PROCEDURES:

Open No. 3 grille door (TM 5-5420-202-10)

Cycle hydraulic

Remova l

1.

Using socket, remove two screws (A)

and lockwashers (B) securing hose guard

(C) to vehicle. Throw lockwashers (B)

away.

G

O

on to Sheet 2

levers (page 3-71)

Cap or plug all lines and manifold (D)

when disconnected. Use masking

tape to tag lines for installation. Use

rags to catch excess hydraulic fluid.

2.

Using wrench, remove hose assemblies

“CV3” (E) and “CV4” (F) from mani-

fold (D).

3.

Slide hose guard (C) off hose assemblies

(E and F).

TA251641

3-251