TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 557 of 750

TM 5-5420-228-24

HOLDDOWN CYLINDER HOSE GUARD REPLACEMENT

INSTALLATION:

NOTE

(Sheet 2 of 2)

Use pipe tape on all male threads before installation. Start tape on second thread

so tape will not enter hydraulic system. Remove all caps and plugs as necessary

during installation.

1. Slide hose guard (A) over two hose

assemblies (B) and (C).

4.

Using wrench, install hose assemblies “CV3”

(C) and “CV4” (B) on manifold (G) as shown.

5.

Close engine right No. 3 grille door (TM-

5-5420-202-10).

2.

Slip hose guard (A) into position against

holddown cylinder armor (D).

3.

Using socket, install two screws (E) and new

lockwashers (F).

End of Task

TA251642

3-252