TM-9-1290-365-24-P
PALADIN MUZZLE VELOCITY SYSTEM M93 UPGRADED
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
OCTOBER 2000
TM-9-1290-365-24-P - Page 243 of 334
ARMY TM 9-1290-365-24&P
Table D-12. Power Supply Module Test Data Sheet
SER. NO. OF MODULE:_______
VOLTAGE OF MODULE:_______
Para.
Min Result
Actual Results
Max. Result
Pass/Fail
Remarks
D.6.11.3.1c.
+4.9Vdc
+5.1Vdc
D.6.11.3.1d.
O
5OmVp-p
D.6.11.3.1e.
650mA
1050mA
D.6.11.3.2c.
V-0.lVdc
V+0.1Vdc
D.6.11.3.2d.
O
5OmVp-p
D.6.11.3.2e
1lOOmA
l700mA
D.6.11.3.2.f
-0.1Vdc
+0.1Vdc
D.6.11.3.3b.
+14.8Vdc
15.2Vdc
D.6.11.3.3c.
O
50mVp-p
D.6.11.3.4b.
-15.2Vdc
-14.8Vdc
D.6.11.3.4c.
O
50mVp-p
D.6.11.3.5b.
+17.8Vdc
18.2Vdc
D.6.11.3.5c.
O
5OmVp-p
D.6.11.3.6a.
-0.1Vdc
+0.1Vdc
D.6.11.3.6b.
+4Vdc
+6Vdc
D.6.11.3.7a
0.7Vdc
1.3Vdc
D.6.11.3.7e.
-0.1Vdc
+0.1Vdc
D6.11.3.8b
+4.9Vdc
+5.1Vdc
D.6.11.3.8d.
14Vdc
16Vdc
D.6.11.3.8g
15Vdc
17Vdc
D.6.11.3.9b.
-0.lmA
+0.1mA
D.6.11.3.9d.
+4.9Vdc
+5.1Vdc
Date:
___________________________
Tested by:
___________________________
Inspected by:
___________________________
D.6.11.4
ADJUSTMENT PROCEDURE.
D.6.11.4.1
PREPARATION FOR TEST. The test is conducted on a disassembled UUT. The test setup is
shown in Figure D-29. Figures D-27. and D-28. are detailed illustrations of the special testers.
a. Remove the UUT from higher assembly lAW para. D.4.6.7.
b. Using soldering iron, remove resistors R16 and R17 from the CCA.
c. Energize and adjust DMM1 to measure resistance.
d. Connect DMM1 to points TP1 and TP2 on the text fixture, and adjust PR1 potentiometer to
17.5KOhm.
e. Adjust DMM1 to measure DC volts.
f.
Energize and adjust DMM2 to measure high DC current (l0 Amp).
D-73
Back to Top
