TM-9-1290-365-24-P

PALADIN MUZZLE VELOCITY SYSTEM M93 UPGRADED

TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST

OCTOBER 2000

TM-9-1290-365-24-P - Page 246 of 334

ARMY TM 9-1290-365-24&P

D.6.1 1.4.5 Deenergize all test equipment.

End of test

Table D-14. Power Supply Module Adjustment Data Sheet

SER NO.

D.6.11.4.2d. SERIAL NO. RF MODULE

DESIRED VOLTAGE V= ____________

D.6.11.4.2e. OUTPUT VOLTAGEl 0+10 Vdc________________

D.6.11.4.3c. MEASURED RESISTANCE

RM______________

D.6.11.4.3d. CHOSEN RESISTORS

R1 6 ______________________

R1 7 ______________________

D.6.11.4.4c. MEASURED Vout = _______________

Date:

____________________________

Tested by:

____________________________

Inspected by:

____________________________

D.6.1 2 Troubleshooting.

This paragraph contains the troubleshooting procedures for UUT failures

detected during testing. It is arranged in the sequence of test steps, and provides information on addi-

tional test steps required for the malfunction isolation. Refer to FO-4 for schematic diagram. Refer to

D-25 for components location.

CAUTION

The power supply module contains components subject to damage by electros-

tatic discharge. Use approved grounding procedures before touching, removing,

or inserting CCA.

CAUTION

Deenergize all external power supplies and other test equipment when

disassembling or reassembling the UUT.

NOTE

In all troubleshooting procedures, when additional disassembly or reassembly is required,

refer to the appropriate disassembly (D.6.5) or reassembly (D.6.10) procedure.

After completion of troubleshooting and repair, perform the complete test procedure from

the start.

In all troubleshooting procedures the test equipment and voltage settings shall be lAW

the test procedure.

Voltages shall be measured to their respective grounds.

D-76

Change 1