TM-9-1290-365-24-P
PALADIN MUZZLE VELOCITY SYSTEM M93 UPGRADED
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
OCTOBER 2000
TM-9-1290-365-24-P - Page 47 of 334
ARMY TM 9-1290-365-24&P
CHAPTER 2
OPERATING INSTRUCTIONS
CHAPTER CONTENTS
Subject
Page
General .
..................................................................................................................................
2-1
MV Min/Max Range .
..............................................................................................................
.2-1
2.1. GENERAL.
The M93 MVS operates as a slave to the M109A6 Paladin Automatic Fire Control System
(AFCS), and as such exchanges data across the MIL-STD-1553B Data Bus. The operator
indirectly controls the MVS by issuing commands to the AFCS. The purpose of this section is to
explain the various MVS associated activities available when running the AFCS software. In
what follows, reference is made to the Version 11 Software Upgrade (TM 9-2350-314-10),
henceforth referred to as the Paladin TM. See the Paladin TM, Para 2-22 for M93 MVS
operating procedures, and to Appendix K for troubleshooting procedures.
2.2. MV MIN/MAX RANGE
The MVS must receive a minimum MV/maximum MV range in order to measure properly. If
actual MVS to be measured do not fall in this range, the MVS will not be able to measure the
MV properly. The AFCS transmits the MV min/max range to the MVS based on the
projectile/propellant/charge combination, which the operator selects when entering the
ammunition data. If the actual ammunition fired does not match the data entered into the AFCS,
the MVS most likely will return measurement errors. Refer to Paladin TM for operating
instructions of proper MV setting.
2-1/(2-2 blank)
Back to Top
