TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 267 of 830

TM 9-2320-209-20-3-1

e.

Adjustment.

FRAME 1

I

1.

2.

3.

4.

5.

6.

7.

Push ENGINE STOP control (1) all the way in.

Pull fuel shutoff valve actuator (2) all the way out (toward firewall).

Slide control cable (3) in clamp (4) so that end of control cable clears fuel

shutoff valve actuator ( 2) by no less than 1/2–inch.

Using 11/32-inch wrench and screwdriver, tighten nut (5) on screw ( 6). Push

fuel shutoff valve actuator (2) all the way in.

Make sure control wire (7) passes through hole in swivel (8) as shown. Using

screwdriver, tighten screw (9). Bend end of control wire up.

Move ENGINE STOP control (1) out and in several times.

Check that fuel shutoff valve actuator (2) and control linkage move smoothly

without binding.

NOTE

Follow-on Maintenance Action Required:

1.

Close hood and left side panel. Refer to TM 9-2320-209-10.

2.

Replace light switch. Refer to para 7-14.

END OF TASK

TA 047404

4-179/(4-180 blank)