TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 259 of 830

TM 9-2320-209-20-3-1

FRAME 3

I

1.

2.

3.

4.

GO

Using left hand, push rack lever (1) toward rear of truck as shown by

arrow. Push lever as far as it will go and hold it.

Using right hand, move control rod (2) to rear as shown by arrow. Move

control rod as far as it will go (pedal in cab hits against stop) and hold it.

Aline hole in rack lever (1) with holes in swivel assembly (3). It should be

necessary to move swivel assembly forward on control rod (2) , squeezing

spring (4) about 1/4 inch.

If spring (4) does not squeeze slightly, control rod (2) must be made

shorter. If spring squeezes too much, control rod (2) must be made longer.

To set length of control rod, refer to adjustment procedure, para 4–29e.

TO FRAME 4

TA 047149

4-171