TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 488 of 830

TM 9-2320-209-20-3-1

FRAME 2

1.

Put starter (1) in position.

Aline three holes in starter mounting flange (2)

with mounting studs (3). Lever (4) must be at top as shown.

NOTE

If starter (1) will not seat firmly against adapter, do

not force it.

It may be due to gear position. Take

starter out, turn starter drive gear slightly, and try

again.

2.

Push starter (1) straight in on mounting studs (3) until it is firmly seated.

Put three lockwashers (5) on three mounting studs.

3.

Screw on and hand tighten three nuts (6) onto three mounting studs (3).

4.

Using 15/16-inch wrench, evenly tighten three nuts (6).

GO TO FRAME 3

7-52