TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 31 of 552
TM 9-2320-209-20-3- 2
13-5. HANDBRAKE CABLE ASSEMBLY REMOVAL AND REPLACEMENT .
TOOLS :
9/16-inch wrench (2 )
1/2-inch wrenc h
7/16-inch wrench (2 )
3/4-inch wrenc h
Long nose plier s
5/16-inch wrenc h
SUPPLIES :
Non e
PERSONNEL: On e
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set, wheel s
chocked .
a.
Preliminary Procedure .
On trucks where spare wheel is under chassis o n
driver’s side, take off spare wheel .
Refer to TM 9-2320-209-10 .
NOT E
Trucks have two types of handbrake levers, over -
center locking lever and ratchet and pawl lever .
This task covers both types .
b. Removal of Overcenter Locking Handbrake Lever Cable .
FRAME
1
1 .
2 .
3 .
G O
Using 5/16-inch wrench, hold shank (1) .
Using 3/4-inch wrench, unscre w
and take off nut (2) from handbrake cable (3) .
Using 1/2-inch wrench, unscrew and take out screw (4) and lockwasher (5) .
Pull handbrake cable (3) free of handbrake lever (6) and clamp (7) .
TO FRAME 2
13-1 8
Back to Top
