TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 23 of 552
TM 9-2320-209-20-3- 2
13-4. HANDBRAKE BRAKESHOES REMOVAL AND REPLACEMENT .
TOOLS :
5/8-inch wrenc h
3/4-inch wrenc h
11/16-inch wrenc h
1 7/16-inch wrenc h
5/16-inch wrenc h
1 5/16-inch wrenc h
7/16-inch wrenc h
Flat-tip screwdrive r
6-inch rule r
Plier s
SUPPLIES :
Spacers (as needed )
PERSONNEL :
On e
EQUIPMENT CONDITION :
Truck parked, engine off, front wheels chocked ,
handbrake released .
a .
Removal .
NOT E
On trucks with exhaust pipe going to rear o f
truck, pipe must be loosened and pushed awa y
from brakeshoes .
For trucks with engin e
LD-427, refer to Part 1, para 5-5. For truck s
with engine LD-465, refer to Part 1, para 5–3 .
For all other trucks, refer to Part 1, para 5-4 .
FRAME 1
1 .
Using 11/16-inch wrench, loosen jamnut (1). Using 5/8-inch wrench, bac k
off adjusting screw (2) .
Lift spring (3) off screw (2) and unhook it .
2 .
Using 7/16-inch wrench, unscrew and take out grease fitting (4) .
3 .
Using 5/16-inch wrench, hold nut (5). Using 3/4-inch wrench, unscre w
and take off nut (6) .
Pull lever (7) off cable end (8) .
4 .
Take off spring (9) from lever (7) .
GO TO FRAME 2
13-1 0
Back to Top
