TM-9-2320-209-20-3-2
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 2 OF 4
MAY 1981
TM-9-2320-209-20-3-2 - Page 40 of 552
TM 9-2320-209-20-3- 2
d. Replacement of Overcenter Locking Handbrake Lever Cable .
FRAME 1
1 .
2 .
3 .
4 .
Find en d
that en d
CAUTIO N
Be careful when putting in handbrake cable (1) so tha t
there are no sharp bends or kinks .
of handbrake cable (1) that has yoke (2) and groove (3) on it. Pu t
of handbrake cable up through hole in bottom of bracket (4) .
Put spacer (5) between groove (3) on cable (1) and bracket (4). Put clam p
(6) over groove .
Line up screw holes in spacer, clamp, and bracket .
Put two screws (7) through clamp (6), spacer (5), and bracket (4). Usin g
9/16-inch wrenches, screw on and tighten two nuts (8) .
Put bracket (4) under cab of truck from the rear and put four studs (9 )
through four holes in floorboard under handbrake lever .
GO TO FRAME 2
13-2 7
Back to Top
