TM-9-2320-209-20-3-4

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4

MAY 1981

TM-9-2320-209-20-3-4 - Page 170 of 410

TM 9-2320-209-20-3-4

FRAME

2

1.

2.

3.

4.

Using phillips screwdriver,

screw two screws (1) through windshield frame (2)

into wiper motor (3). Tighten screws.

Clip wiper blade (4) to wiper arm (5).

Put wiper arm (5) on serrated shaft of wiper motor (3). Set arm so that blade

clears windshield center post (6) and windshield frame (2) by turning manual

control lever (7) to the right and left.

Using 3/8-inch wrench,

screw on and tighten cap nut (8).

NOTE

Follow-on Maintenance Action Required:

Start engine and turn on windshield wiper control valve

to check operation of wiper motor. Refer to TM

9-2320-209-10.

END OF TASK

21-7