TM-9-2320-209-34-2-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 1 OF 3

MAY 1981

TM-9-2320-209-34-2-1 - Page 499 of 770

TM 9-2320-209-34-2-1

b. Removal of Bearing from Shaft by Pulling.

TOOLS : No special tools required

SUPPLIES: None

PERSONNEL: One

1.

Put puller plate (1) on shaft (2) with bearing (3) as shown. Close puller

plate until inner race (4) of bearing (3) rests on puller plate but plate

does not touch shaft (2).

2.

Tighten two nuts (5) to keep puller plate (1) from opening.

3. Put puller wrench (6) on push-puller (7) as shown. Screw in and

tighten two legs (8) into puller plate (1).

4.

Pull bearing (3) off shaft (2).

END OF TASK

10-100