TM-9-2320-209-34-2-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 3

MAY 1981
TM-9-2320-209-34-2-2

  TM-9-2320-209-34-2-2 - Page 623 of 899

TM 9-2320-209-34-2-2
FRAME 3
1.
Turn wormgear shaft (1) until worm wheel (2) meshes with wormgear in
wormgear assembly housing (3).
2.
Facing end of worm gear assembly housing (3), check that worm gear in
wormgear assembly housing is centered over worm wheel (2). If wormgear is
not centered, take out two screws (4) and add or take off a shim (5) until
wormgear is centered. Put in two screws.
3.
Check that ends of worm gear shaft (1) have no play in them. If ends of
shaft have play, set worm adjusting bearing. Refer to para 17-49g.
GO TO FRAME 4
17-606


Back to Top