TM-9-2320-209-34-2-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 3

MAY 1981

TM-9-2320-209-34-2-2 - Page 615 of 899

TM 9-2320-209-34-2-2

FRAME 2

1.

2.

3.

4.

GO

Put key (l) in wormgear shaft (2). Aline key with keyway in thrust washer (3).

CAUTION

Key (1) in shaft (2) must clear thrust washer (3). Key must

not bind adjusting bearing (4). Damage to equipment may

result if needed clearance is not set up.

Tap shaft (2) through thrust washer end of housing, rounded end first. Set shaft so

that square end sticks out the same distance as noted.

Finger tighten adjusting bearing (4).

Check clearance of key (1) by turning shaft (2). Shaft must turn freely.

TO FRAME 3

17-598