TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 139 of 592

TM 9-2320-209-34-2-3

FRAME 16

1.

2.

3.

4.

5.

6.

7.

8.

9.

10.

Turn sleeve (1), until the tapped hole is alined with the groove in brake

plate (2).

Put in capscrew (3) and washer (4).

Be sure that capscrew (3) goes into groove in brake plate (2). Tighten

capscrew.

Turn sleeve (1) on brake plate (2). Be sure it moves freely. If not, check

capscrew (3) installation.

Try to turn brake plate (2) on drumshaft (5). If plate turns, take off brake

plate and check keys (6) on drumshaft (5).

Slide sleeve (1), back and forth on brake plate (2). Sleeve must hold in two

positions on clutch detent action.

Move sleeve (1) away from flange on brake plate (2). Clutch spring (7) must

force brake plate back until plate is locked in position by clutch detents.

Move sleeve (1) toward flange on brake plate (2). Brake plate must force

spring (7) to squeeze until detents hold plate in this second position.

Put further pressure in the same direction on sleeve (1). Sleeve must cause

brake plate (2) to squeeze spring (7) another 5/32 inch.

Back off pressure on sleeve (1). Spring (7) must force brake plate (2) back

until detents hold in the second position. Plate must not snap back to first

position.

If sleeve (1) and brake plate (2) do not move properly for all of these

conditions, check clutch detent installation.

GO TO FRAME 17

18-128