TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

  TM-9-2320-209-34-2-3 - Page 135 of 592

TM 9-2320-209-34-2-3
FRAME 12
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
GO
If drumshaft (1) is being replaced, the two taper pin holes must be drilled
in the replacement shaft.
Find out the location of the two tapered pin holes in the old shaft by measuring
from the collar location on the drumshaft before it was taken out.
Drill and taper-ream these holes for pins (2 and 3).
Take out pin (4) from the old drumshaft (1) and press in new one.
If either bearing (5) was removed from end of drum (6) press in new
bearing.
Slide collar (7) on drumshaft (1) against pin (4).
Slide collar (8) on drumshaft (1).
Put keyed end of drumshaft (1) through drum (6).
Slide collar (9) on drumshaft (1) and hold in place with pin (3).
Slide drum (6) against collar (9) and slide collar (8) against drum (6).
Hold in place with pin (2).
TO FRAME 13
18-124


Back to Top