TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

  TM-9-2320-209-34-2-3 - Page 128 of 592

TM 9-2320-209-34-2-3
FRAME 5
1.
Pack thrust bearings (1 and 2) with
type
GAA
lubricating grease, MIL-G-10924.
2.
Put bearing assembly (1) on wormshaft (3).
3.
Put washer (4) and shim set (5) on worm shaft (3).
NOTE
Be sure to use shim set which was fixed for proper
clearance in frame 3.
4.
Put bearing assembly (2) on wormshaft (3).
5.
If oil seal (6) was taken off bearing retainer (7), press new seal into
retainer with lip of seal facing inside of retainer.
6.
Put retaining plate (8) on bearing retainer (7).
7.
Put on four capscrews (9) and washers (10).
GO TO FRAME 6
18-117


Back to Top