TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

  TM-9-2320-209-34-2-3 - Page 121 of 592

TM 9-2320-209-34-2-3
FRAME 10
1.
2.
3.
4.
5.
6.
Check that worm (1) and sprocket (2) have no sharp fins or burrs at
tooth corners. If worm and sprocket are damaged, get new ones. Smooth
out small damage with a honing stone.
NOTE
If new worm (1) is being put in, you must order worm
assembly, consisting of worm (1), collar (3), and
stud (4).
Check that worm (1) and sprocket
sprocket (2) are cracked, get new
Check that worm (1) and sprocket
If any teeth are damaged, get new
(2) is not cracked.
ones.
(2) have no chipped
worm and sprocket.
If worm (1) and
or broken teeth.
Put clean oil ICE, OE/HDO 10, MIL-L-2104 on each bearing (5 and 6) and
turn slowly by hand. The bearing must turn without binding. If bearing
assemblies are worn or damaged, get new ones.
Check that bearing rollers (5) are not grooved, pitted, or flattened. If
bearing rollers are worn or damaged, get new ones.
Check that bearing cups (6) are not scored and pitted. If bearing cups are
damaged, get new ones.
GO TO FRAME 11
18-110


Back to Top