TM-9-2320-272-23-3
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-3 - Page 217 of 1469
REMOVAL
NOTE
Front and rear side markers are replaced basically the same. This procedure is for rear side
marker light.
1.
Disconnect wiring harness connector (Figure 1, Item 1) from connector (Figure 1, Item 6).
2.
Remove locknut (Figure 1, Item 7), screw (Figure 1, Item 8) and clamp (Figure 1, Item 9) from rail
(Figure
1,
Item
2). Discard locknut.
3.
Remove wiring harness (Figure 1, Item 3) from clamp (Figure 1, Item 9).
4.
Disconnect wiring harness connector (Figure 1, Item 4) from connector (Figure 1, Item 5).
5.
Remove wiring harness (Figure 1, Item 3) from vehicle.
M7000DAA
7
9
8
6
1
2
3
4
5
Figure 1.
Side Marker Light Wiring Removal.
END OF TASK
INSPECTION
If banded, remove band and lay wiring harness flat for inspection. Inspect wiring harness for frays, splits, or
missing or damaged insulation. Repair or replace affected wiring.
END OF TASK
REPAIR
Repair wiring harness as needed (WP
0352).
END OF TASK
TM 9-2320-272-23-3
0360
0360-2
Back to Top
