TM-9-2320-272-23-3

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 3 OF 5

SEPTEMBER 2012

  TM-9-2320-272-23-3 - Page 499 of 1469

REMOVAL
1.
Remove cotter pin (Figure 1, Item 5), pin (Figure 1, Item 7), and shift rod (Figure 1, Item 6) from shift lever
(Figure 1, Item 2). Discard cotter pin.
2.
Remove cotter pin (Figure 1, Item 4), washer (Figure 1, Item 3), pin (Figure 1, Item 8), and shift lever
(Figure
1,
Item
2) from shift lever bracket (Figure 1, Item 9). Discard cotter pin.
WARNING
Solvent cleaning compound is flammable and toxic. Do not use near an open flame and
always have a fire extinguisher nearby when solvents are used. Use only in well-ventilated
places, wear protective clothing, and dispose of cleaning rags in approved container. Failure
to comply may result in damage to equipment, injury, or death to personnel.
3.
Clean shift lever (Figure 1, Item 2) with cleaning compound solvent.
4.
Inspect shift lever (Figure 1, Item 2) for cracks and breaks. Replace shift lever if cracked or
broken.
5.
Inspect shift lever bushing (Figure 1, Item 1) for cracks, breaks, and pits. Remove pits with crocus cloth.
Replace shift lever bushing if cracked or broken.
NOTE
Perform Steps (4) and (5) if bushing requires replacement.
6.
Using arbor press, remove bushing (Figure 1, Item 1) from shift lever (Figure 1, Item 2). Discard bushing.
7.
Using arbor press, install bushing (Figure 1, Item 1) on shift lever (Figure 1, Item 2).
TM 9-2320-272-23-3
0396
0396-2


Back to Top