TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 111 of 801

TM 9-2320-273-34

(7)

M920 – Install quarter fender support tube (fig. 2-55) and Secure to vehicle frame with

capscrew and nut.

(8)

M920 – Mount quarter fender on support tube (fig. 2-54) and secure with capscrew.

washer, and nut.

(9)

Repeat steps (4), (5) and (6) for attaching parts on other side of vehicle for all models;

and steps (7) and (8) on model M920.

(10)

Tighten attaching parts in steps (4) through (9) to the following torque.

(a)

Eight alien-head capscrews: 150 Ib-ft (203 N-m).

(b)

Sixteen hex-head capscrews (including the one for the quarter fender support tube):

75 Ib-ft (102 N-m).

(11)

(12)

(13)

(14)

(15)

(16)

(c)

T

WO

capscrews on quarter fender clamps: 83 Ib-ft ( 113 N-m).

(d)

T

WO

nuts on air reservoir support hanger: 31 Ib-ft (42 N-m).

Remove jack.

Install intermediate propeller shaft. (Refer to TM 9-2320-273-20.)

Connect air line (1, fig. 2-53).

Connect air lines (2).

Connect air lines (3).

M920 – Install walk plate (1, fig. 2-52) and secure with four J-bolts (3) and (6). Make sure

that nuts (2 and 7) are tight.

-

(17)

Install clamp (5) on each hose and secure clamps to walk plate with capscrew (4), washer,

and nut.

(18)

Lubricate pusher axle assembly. (Refer to LO 9-2320-273-12.)

(19)

Start up and operate engine to build up system air pressure. (Refer to TM 9-2320-273 -10.)

(20)

Check operation of pusher axle by raising and lowering the assembly several times. Check

for leaks with system under maximum air pressure (160-190 psi).

2-95/2-96 (Blank)