TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 241 of 801

TM 9-2320-273-34

b. Preparation.

(1)

Drain the oil from the transmission.

(2) Install a plate (1, fig. 7-58) over the ports for umb

(3)

in the air source port,

Iical cord mounting flange and a plug

Figure 7-58, Remove Transmission Control.

(3)

Thoroughly clean the outside of the transmission.

c.

Remove and Disassemble Transmission Control.

(1)

If required, remove twelve breathers (4) (Refer to TM

9-2320-273-20).

(2)

Remove twenty bolts (6) and washers (7) from around the outside of the transmission

control. (It is not necessary to remove bolts

(5). )

(3)

Remove two bolts

(8)

install two eye bolts.

Using a suitable lifting device remove trans-

mission control (2) and the gasket.

(4)

Remove and disassemble pressure regulator. (Refer to para 7.8d, ) Note location, number

and thickness of shims,

Change 2

7-63