TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 244 of 801

TM 9-2320-273-34

(5)

Install two 3/8-16 forged eyebolts in the brake plate. Use a hoist to remove the rear brake

(3) approximately three inches; then remove bearing (1). It may be necessary to tap end of shaft with a

mallet to loosen bearing. Place brake plate on wood blocks (see fig. 7-62).

(6)

Remove 12 bolts

NOTE

In step (6), loosen bolts evenly – a few

turns at a time on each – until all are out.

Scribe plate to aid in reassembly.

(1, fig. 7-61), washers (3), and plate (2) from the brake assembly.

7-66