TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 235 of 801

TM 9-2320-273-34

a.

Removal.

(1)

Disconnect propeller shaft at transmission yoke; then remove the yoke. (Refer to TM

9-2320-273 -20.)

(2)

Disconnect speedometer cable, refer to TM 9-2320-273-20.

Steps 3 and 4 must be accomplished

as described; otherwise transmission

disassembly will be necessary.

(3) Remove any two capscrews

and washers ( 180° apart) that fasten rear bearing support

housing to transmission case (fig. 7-53).

REAR BEARING SUPPORT HOUSING

Figure 7-53. Remove Rear Bearing Support Housing.

(4)

Thread a 6-in. long rod (3/8-16 NC bar stock) into each of the removed capscrew holes. Use

minimum torque. Leave both rods installed for support housing installation.

(5)

Remove four remaining capscrews in support housing.

7-57

CAUTION