TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 324 of 801

TM9-2320-273-34

The oil pump drive gear and front

clutch must be engaged before the

nut (1, fig. 7-141) is tightened in

the next step. Look through opening

in bottom of case and observe that

oil pump gear turns when front

clutch is turned. Failure to observe this

precaution will result in damage to the

oil pump assembly.

(21) Install spacer (5) bearing (4), seal (3), retainer (2) and nut (1) on the shaft. Move the

shifting forks so that the clutch will not turn; then torque nut (1) to 275 ± 25 Ib-ft (370 ± 35 N-m).

1.

NUT

2. RETAINER

3. SEAL

4. BEARING

5. SPACER

TA 074178

Figure 7-141. Install Bearing.

7-146

Change 2

CAUTIO N