TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 321 of 801

TM9-2320-273-34

With the centrifugal piston in its forward position,

use spacer plates on top of the last disk to obtain

a new unit clearance of 0.130 ± 0.015 in. (3.30 ±

0.38 mm) between the hub surface and the spacer

plate surface. Used unit clearance maximum is

.175 in. (4.44 mm).

(15) position the 12 springs in the hub. Leave four empty spacers 90° apart, as shown.

NOTE

Make sure springs are in alinement with plate.

(16) position plate (fig. 7-138). Evenly install the bolts that hold it a few turns at a time on

each until all bolts are turned down. Tighten to 36 ± 2 Ib-ft (46 ± 2 N-m) torque.

Figure 7-138. Install Clutch Plate.

Change 2

7-143

NOT E