TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 312 of 801

TM9-2320-273-34

(24)

(25)

(26)

Install snapring (7) on the shaft.

Position bearings races (5) and bearing (8) on hub (4).

NOTE

It may be necessary to line up the teeth

of plates and disks (9) so that hub (4)

will seat fully and snap ring can go on.

Position hub (4) on the shaft lining up the blind spline on inside of gear with blind spine on

the shaft. (Make sure that hub is installed as shown in illustration, not backwards.)

(27) Install snapring that secures hub (4) to shaft.

(28) Apply liquid gasket to the mating surfaces of the front brake and the front housing.

(29) Install a 3/4-10 NC eyebolt in the housing (fig. 7-129). Fasten a hoist to the eyebolt and

position the housing on the front brake. Install the 21 bolts (three different lengths - see fig. 7-129)

that hold it and torque to 55 ± 5 Ib-ft (75 ± 7 N-m).

(30) If removed, install upper plug, orifice plug, and lower plug.

7-134

TA 074166

Figure 7-129. Install Front Housing.