TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 304 of 801

TM9-2320-273-34

(2) Heat bearing (3) in oil to a maximum temperature of 275°F (135°C). Install bearing on

the shaft. Make sure the groove in the bearing is toward the end of the shaft which has threads on it.

Install the snapring on the shaft on the other side of the bearing.

(3) Install two new seal rings (2) on the shaft. Apply a light coat of silicone grease (item 22,

Appendix B) on each ring and groove.

(4) Put roll pin (1) in position on the bearing retainer and install retainer. Install three

keepers (7). Apply a light coat of silicone grease to hold keepers in place.

(5) Install plug (6).

(6) Install new seal ring (5).

(7) Install the shaft (fig. 7-121) in the front case of the transmission. Make sure roll pin in

retainer lines up with cutout in case.

TA 074160

Figure 7-121. Install Shaft in Front Gear.

7-126