TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 340 of 801

TM9-2320-273-34

(37) If end clearance is not correct remove rear bearing retainer assembly and add shims to in-

crease clearance or remove shims to decrease clearance. Reinstall retainer assembly.

(38) Remove dial indicator and installer and install the O-ring, retainer, yoke, and center bolt

on the output shaft.

g.

Assemble and Install Transmission Control.

(1)

Assemble and install Pressure regulator as described in para 7-8e.

(2) perform seal leakage tests for clutches and brakes as described in para

7-14.

(3)

put the transmission control (2, fig. 7-157) in position on transmission case.

(4) Install 20 bolts (6) and two short bolts (5). Torque to 36 ± 2 Ib-ft (49 ± 3 N-m).

(5)

If required, install twelve breathers (4) (Refer to TM 9-2320-273-20).

LEGEND:

1.

PLATE

5. BOLT (2)

2. TRANSMISSION CONTROL

6. BOLT (20)

3. PLUG

7. WASHER (20)

4. BREATHER (12)

8. BOLT (2)

Figure 7-157. Install Transmission Control.

TA 239533

7-20. Installation.

Install transmission as described in Chapter 2, para 2-11 b.

7-162

Change 2