TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 65 of 801
TM9-2320-273-34
(18)
Connect air pressure line to transmission.
CAUTIO N
In step (18), make sure that holes in
gasket for control flange are alined
with guide pins.
(19) Remove tape and connect umbilical cord air control flange, plate and gasket to
transmission. Tighten capscrews to 108 lb-in (12 N-m).
Tighten
(20) Install engine retarder switch, if removed. Connect wires to terminals.
(21) Connect clamp to air pressure line. Secure to transmission case with capscrew and washer.
to 36±2 Ib-ft (46 ± 3 N-m) torque.
(22) If removed, install ratio selector (fig. 2-20). Secure with capscrews and washers. Tighten
capscrews to 36 ± 2 Ib-ft (46 ± 3 N-m) torque.
TA 073961
Figure 2-20. Install Ratio Selector Assembly.
.
2-49
Back to Top
