TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 651 of 801

TM9-2320-273-34

c.

Apply a thin coat of lubricant to the outer diameter of the end bushing.

d.

Use adapter identification No. 2 (Table 18-1) to fit over rubber and press against jaws of the

puller to install bushing into end beam (fig. 18-9). The bushing should be installed to meet the speci-

fications in figure 18-8. Once installed, remove puller.

e.

Apply a thin coat of lubricant to the outer diameter of the center bushing.

f.

M915). Using adapter identification No. 3 (Table 18-1), install center bushing to meet

specifications in figure 18-8.

9.

(M916

thru

(M920). Using adapter identification No. 3 (Table 18-1), install center bushing

assembly into equalizer beam. The lube grooves must be in alinement with the vertical center line on

the equalizer beam and when installed, the bushing must be equal distance from sides of equalizer

beam (fig. 18-8).

h.

(M4916

thru

(M920). Install oil seals by gently tapping on outer edge.

18-16. Installation.

Install equalizer beam and rear tandem axle (refer to para 2- 16 b).

18-14