TM-9-2320-273-34

TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 1980

TM-9-2320-273-34 - Page 641 of 801

TM9-2320-273-34

d.

Install the alinement clamps in their original positions. Torque the nuts 45-55 Ib-ft (61-74

N.m).

e.

Remove the spring assembly from the vise.

18-5. Installation.

Position spring on a hydraulic jack and raise into place. Position the front spring eye with the

bolt hole in the front bracket and install the bolt, washer, and nut (fig. 18-1). Do not tighten at this

time.

b.

Aline the rear spring eye with the shackle bolt hole and install the bolt and nut. Torque bolt

to 300-400 Ib-ft (407-452 N.m). Install cotter pin.

c.

Torque bolt on the front spring eye to 300-400 Ib-ft (407-452 N.m). Install cotter pin.

d.

Depending on vehicle model being serviced, refer to para 2-14c or 2-15c and install front

axle assembly.

18-4

a.