TM-9-2320-273-34
TRUCK TRACTOR, LINE HAUL; LIGHT EQUIPMENT TRANSPORTER; TRUCK CHASSIS; MEDIUM EQUIPMENT TRANSPORTER
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1980
TM-9-2320-273-34 - Page 79 of 801
TM9-2320-273-34
When the engine is being removed, observe
the following:
a. Engine binds or is hard to move (an
indication something may still be
connected to engine that must be
removed).
b. Wiring, lines, cables, and rods are not
in the path of removal. Tie or secure
as necessary.
c. Pay particular attention to the alter-
nator on all models and power
steering pump on M915 – clearance
to vehicle frame is close.
(29) With two men guiding the engine out (one on each side), slowly lift engine and move clear
of vehicle.
b. Installation.
(1) Inspect engine compartment and make sure that all wiring, tubing, and other components
present no obstruction to engine installation.
(2) Using a hoist, attach sling to support the engine as shown in figure 2-32.
Pay particular attention to the alternator
and power steering pump during engine
installation –clearance to vehicle frame
is close.
(3) With two men guiding the engine in (one on each side), slowly move engine into engine
compartment and lower onto frame mounts.
(4) Install engine mounting capscrews (fig. 2-33); two at front of engine and one on each side
at rear. Tighten to 125-165 Ib-ft (170-223 N·m) torque.
2-63
CAUTIO N
CAUTIO N
Back to Top
