TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012
TM-9-2320-283-13-P

  TM-9-2320-283-13-P - Page 260 of 400

TM 9-2320-283-13&P
0036
0036-2
CLEANING–CONTINUED
WARNING
There are no adverse effects on human health associated with the use
of MIL-PRF-680 when used as intended; however when used indoors,
ventilation shall be sufficient to prevent the accumulation of vapors
above allowable exposure limits. Failure to comply may result in
injury to personnel. Seek medical attention in the event of an injury.
When applying and removing MIL-PRF-680 Type II or IV degreasing
solvent, personnel shall wear chemical-resistant gloves and a face
shield or goggles to prevent skin and eye contact with solvent and oil,
grease, and other contaminants removed with solvent. In case of skin
contact, remove any contaminated clothing before reuse. In the event
of eye contact, flush eyes with large amounts of water for at least 15
minutes or until irritation subsides. Do not have food or drink in the
vicinity. Failure to comply may result in injury to personnel. Seek
medical attention in the event of an injury.
CAUTION
Before opening reservoir, ensure area around reservoir filler cap is
clean. Do not allow dirt, dust, or water to enter reservoir. Failure to
do this may cause damage to internal components.
3.
Oil and Grease Covered Surfaces. Using MIL-PRF-680, Type II or IV, degreasing solvent clean oil and
grease from exterior surfaces of bridge prior to cleaning dirt, mud, and debris with soap and water.
CAUTION
Do not allow cleaning solvent to come in contact with seals or
flexible hoses. Failure to comply will result in damage to parts.
4.
Oil Seals and Flexible Hoses.
5.
External Surfaces. Clean all accessible external surfaces of vehicle with soap and water and rinse
thoroughly. Use power wash pump when cleaning to save time and effort.
NOTE
All parts subject to rusting must be lightly oiled after cleaning and
prior to storage.
6.
Remove all evidence of corrosion from rusted surfaces.
END OF TASK
PAINTING
The M915A1 tractor will require touch-up of painted surfaces periodically. The M915A1 is painted with
Chemical Agent Resistant Coating (CARC) paint; notify Field Maintenance if components require touch-up of
painted surfaces.
END OF TASK


Back to Top