TM-9-2320-283-13-P

ANTI-LOCK BRAKE SYSTEM (ABS) M915A1

TECHNICAL MANUAL; OPERATOR AND FIELD MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST (RPSTL)

AUGUST 2012

TM-9-2320-283-13-P - Page 252 of 400

TM 9-2320-283-13&P

0034

0034-2

REMOVAL – CONTINUED

3.

Disconnect left rear wheel sensor cable plug (figure 2, item 1) from left rear wheel sensor harness

connector (figure 2, item 2).

4.

Disconnect left rear modulator harness plug (figure 2, item 3) from left rear modulator receptacle

(figure 2, item 4).

5.

Perform steps 1 through 4 to disconnect right front and right rear wheel sensor cables and modulators.

1

2

3

4

Figure 2. Disconnecting Rear Wheel Sensor and Modulator Harnesses.

CAUTION

Exercise caution not to cut harnesses when cutting tie straps during

removal of wheel sensor and modulator harnesses. Failure to comply

may result in damage to equipment.

NOTE

Note location of wheel sensor and modulator harness routing during

removal of tie straps.

6.

Cut and remove tie straps at each modulator (figure 3, items 2) while pulling wheel sensor harness leads

(figure 3, items 1) and modulator harness leads (figure 3, items 2) through frame until all harness leads

hang from bulkhead connectors (figure 3, items 4 and 5) at left-hand frame rail (figure 3, item 3).

Discard tie straps.