TM-9-2320-283-20-1
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE PART 1 OF 3
DECEMBER 1983
TM-9-2320-283-20-1 - Page 464 of 926
TM 9-2320-283-20-1
STE/ICE TROUBLESHOOTING.
2-16.
STE/ICE DESCRIPTION AND OPERATION (Continued).
ERROR READOUT (Continued)
VTM Readout
Interpretation
E002
Indicates
that the
required
transducer is
not
connected or installed.
E003
Indicates
that a test
number has
been dialed which
does not apply to the vehicle under test.
It
can
only
occur in the DCA mode.
E004
Indicates that
a vehicle
identification number
or
number of cylinders information has not been entered.
EO5
Indicates that the transducer offset test was not performed.
E007
Indicates conflict
between the
vehicle
identification number (VID) dialed in and the number of cylinders
dialed in.
It may occur in response to either VID entry or number of cylinders entry.
E008
Indicates the VTM is not receiving the required
voltage signal for
the test
selected.
This error
code is
related only to starter and compression balance tests.
EOO9
Indicates that the engine was
not running at the start
of the
test.
EO1O
A wrong vehicle number was dialed into the VTM.
EO11
Indicates
that the
throttle control was
operated incorrectly during power test taking; too much time to either
accelerate or decelerate.
E013
Indicates bad data was
taken for the test in progress.
Repeat the test one (1) time.
E014
Indicates that a wrong number of cylinders
was dialed into the.
VTM.
E018
Indicates that an engine RPM or AC frequency test was terminated automatically to protect the VTM.
Termination is only after several minutes
of no-signal operation.
Most likely, the VTM was left on the truck
and the engine stalled.
2-339
Back to Top
