TM-9-2320-283-20-1

TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, M915A1

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE PART 1 OF 3

DECEMBER 1983

TM-9-2320-283-20-1 - Page 465 of 926

TM 9-2320-283-20-1

STE/ICE TROUBLESHOOTING.

2-16.

STE/ICE DESCRIPTION AND OPERATION (Continued).

e.

Cable Assemblies.

(1)

General.

The cable assemblies are shown below and are referred to by the

cable number and

by a

name which describes

how the

cable is used.

If necessary, the two transducer cables (W4) can be joined with the

adapter

(2)

Installation.

When cables are connected, a large key on the cable connector mates with a keyway on

the transducer connector or the VTM connector for proper installation.

If you experience any difficulty during testing

and

f.

Transducer Kit.

(1)

General.

The transducer kit contains a pulse tachometer transducer, a pressure, and a vacuum

transducer plus the necessary adapters (bushings, plugs, tees, etc.).

Also included in the kit is a current probe for

measuring current and a test probe cable for measuring voltage and resistance.

All fittings do

not have

part number markings.

The legend

will help to identify the items.

Before installing any transducer kit item on the truck, be sure to clean the mounting surfaces.

This is particularly important

if you are going to open fuel lines or tap into manifolds.

Dirt particles entering the engine can cause damage to both the

engine and the transducer kit item.

TA 236971

2-340