TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 318 of 570
TM 9-2320-283-34-2
SPRINGS, SHOCK ABSORBERS, AND TORQUE RODS.
3-101. REAR TANDEM AXLE SPRING HANGER REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
NOTE
Rear tandem axle spring hangers on the
right side of truck are same
as those
on left side.
This procedure applies
for hangers on either side of truck.
1. Frame assembly (6).
a. Using suitable lifting
device, lift until weight
of vehicle is off item
(14).
2. Froward-rear axle
assembly (15).
3. Nut (9) and lock-
washer (8).
4. Drawkey assembly
(16).
5. Fitting (17).
6. Pin (18).
7. Two screws (1)
and nuts (4).
8. Six screws (1),
nuts (4), bracket
(5), hanger (2),
and plate (3).
b. Support with jack stands.
Using floor jack, raise until
weight of item (14) is off
item (2).
Remove from item (16).
Drive out of item (2).
Remove from item (18).
Drive out of items (2) and
(14).
Remove from items (2), (3),
and (6).
Remove from item (6).
Adjust floor jack as
neccessary to relieve
tension of item (18) in
items (2) and (14). To
check for tension, put
screwdriver in slot of
item (18) and turn.
Force item (14) down if
necessary to remove item
(2).
3-874
Back to Top
