TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 322 of 570
TM 9-2320-283-34-2
SPRINGS, SHOCK ABSORBERS, AND TORQUE RODS.
3-101. REAR TANDEM AXLE SPRING HANGER REPLACEMENT (Continued).
LOCATION/ITEM
ACTION
REMARKS
17. All parts.
Clean.
Refer to paragraph 3-4.
18. All parts.
19. Hanger (2).
Inspect.
Refer to paragraph 3-5.
Inspect outside pin hole for
Discard item (2) if hole
cracks and elongation.
is elongated or if area
around hole is cracked.
20. Spacer (12), bolt
(13), lockwasher
(8), and nut (9).
21. Hanger (7).
22. Hanger (11),
three screws
(1), and nuts (4).
23. Rear-rear axle
assembly (15).
24. Hanger (7),
bracket (5), six
screws (1), and
nuts (4).
Install in item (7).
Slide onto item (14).
Install on item (6).
Using floor jack, raise until
holes in item (7) line up
with holes in item (6).
Install on side of item (6),
but do not tighten.
Torque item (9) to 70-80
lb-ft.
Item (12) should be
under item (14) when
installed.
Tighten three items (4).
Do not install two items
(1) and (4) in bottom of
item (7) and (6) until
step 28.
3-878
Back to Top
