TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 60 of 570
D. ASSEMBLY
TM 9-2320-283-34-2
REAR TANDEM AXLES.
3-68. DIFFERENTIAL CARRIER COVER REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
NOTE
Position a block of wood, 4 inch x 4
inch x 4 inch, under the shift fork to
prevent it from falling out when dif-
ferential carrier cover is reversed.
42. Clutch (38).
Slide onto item (2) with
clutch teeth facing item
(41).
43. Shaft (2).
Install through the front of
item (36).
It may be necessary to
rotate item (2) so that
engages onto item (19).
44. Retainer (6).
Install onto item (36).
Install without items
(5).
45. Five screws (10)
Install in item (6) finger
and washers (11).
Items (10) and (11) will
tight only.
be removed for checking
and adjusting end play
in step 60.
46. Yoke (8), washer
(9), and nut (3).
Install onto item (2) and
Refer to step 45.
temporarily tighten item (3).
47. Nut (18).
Install on item (17) and
Hold item (8) when
torque to 35-45 lb-ft.
torquing item (18).
48. Washer (1), washer
Install in that order onto
(39), gear (41),
Item (1) is a steel
item (2).
and ring (42).
washer and item (39) is
a bronze washer.
49. Cone (22).
Install onto item (21) using
Protect gear teeth of
suitable mandrel and hydrau-
item (21) during
lic press.
press operation.
50. New bushing (26).
Install into item (27) using
suitable bushing installer.
51. Assembled gear
(21), cone (22),
Install onto item (27).
Clamp item (27) in a
vise.
and cup (23).
3-616
Back to Top
