TM-9-2320-283-34-2
TRUCK TRACTOR, LINE HAUL, 50,000 GVWR, 6X4, MQ15A1
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
DECEMBER 1983
TM-9-2320-283-34-2 - Page 62 of 570
E. ADJUSTING
D. ASSEMBLY
TM 9-2320-283-34-2
REAR TANDEM AXLES.
3-68. DIFFERENTIAL CARRIER COVER REPAIR (Continued).
LOCATION/ITEM
ACTION
REMARKS
52. Snapring (20).
Install onto end of item
(27).
If item (24) was removed
during disassembly,
installation will be
similar.
53. Two new O-rings
Install onto item (27).
(25).
54. Four bushings
Install onto each shaft of
(32), pinion (33), item (31).
and washers (34).
55. Assembled spider
Install in one half of item
Make certain previously
(31).
(29) and place the remaining
made, punch marks are
half of item (29) onto item
alined.
(31).
56. Eight bolts (30)
Install into holes of item
and new nuts (28).
(29) and torque to 17-23
lb-ft.
NOTE
To adjust end play, the assembled
output shaft,
interaxle differential
and differential carrier cover must be
installed on the differential carrier.
57. Assembled cover
Install onto differential
(36).
Refer to paragraph 3-67
carrier.
for installation.
58. Differential
Mount in suitable differen-
carrier with
tial stand.
carrier cover
(36).
59. Nut (3), washer
Remove from items (2) and
Items (3), (9), (8),
(9), yoke (8),
(36).
(10),
and (11) were
five screws (10),
and washers (11).
installed finger tight.
3-618
Back to Top
