TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

  TM-9-2320-328-13-P-1 - Page 1204 of 1318

TM 9-2320-328-13&P-1
0107-10
DRAFT
0107
Change 1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
HWT3287
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 14.
Note position of non-operating upper rear warning light.
Remove driver side rear light
bezel cover (WP 0335).
Put EMERG MASTER and UPPER REAR WARNING switches
to off position (WP 0004).
Turn Service Drive Lights Off (TM 9-2320-422-10).
Disconnect operating driver side body wire harness upper rear warning light connector
from warning light (WP 0231).
Disconnect non-operating driver side body wire harness
upper rear warning light connector from warning light (WP 0231).
Connect
non-operating upper rear warning light to operating driver side body wire harness
connector.
Turn Service Drive Lights On (TM 9-2320-422-10).
Put EMERG MASTER
and UPPER REAR WARNING switches to on position (WP 0004).
Check if upper rear
warning light in non-operating position operates.
.
If warning light connected to non-operating driver side body wire harness
connector operates, replace non-operating warning light (WP 0231).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION


Back to Top