TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

  TM-9-2320-328-13-P-1 - Page 1205 of 1318

TM 9-2320-328-13&P-1
0107-11
DRAFT
0107
Change 1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
HWT3288
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 15.
Note position of non-operating upper rear warning light.
Put EMERG MASTER and
UPPER REAR WARNING switches to off position (WP 0004).
Turn Service Drive
Lights Off (TM 9-2320-422-10).
Pull battery disconnect switch to off position
(WP 0007).
Disconnect driver side body wire harness upper rear warning light
connector from non-operating upper rear warning light (WP 0231).
Check for continuity
across driver side body harness wire 2640 (black) from non-operating warning light
connector, terminal 1 to a known good ground.
.
a.
If there is continuity, repair wire 1613 in driver side body wire harness if
repairable (TM 9-2320-325-14&P), or replace driver side body wire
harness (WP 0286).
.
b.
If there is no continuity, repair wire 2640 in driver side body wire
harness if repairable (TM 9-2320-325-14&P), or replace driver side
body wire harness (WP 0286).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION


Back to Top