TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

  TM-9-2320-328-13-P-1 - Page 1225 of 1318

TM 9-2320-328-13&P-1
0108-7
DRAFT
0108
Change 1
.
HWT1184
.
WARNING
.
ICON 3
.
Remove rings, wristwatches, neck chains, and any other jewelry before working
around vehicle.
Jewelry can catch on equipment and cause serious injury.
Jewelry
and tools may short across electrical circuits and cause damage to equipment, or
severe burns or electrical shock to personnel.
.
Step 7.
Put DRIVER SCENE switch to off position (WP 0004).
Turn Service Drive Lights
Off (TM 9-2320-422-10).
Pull battery disconnect switch to off position (WP 0007).
Remove driver side rear light bezel cover (WP 0335).
Disconnect driver side body wire
harness rear driver side scene light connector.
Push battery disconnect switch to on
position (WP 0007).
Put DRIVER SCENE switch to on position (WP 0004).
With a test
lead set, check for 22 to 28 VDC between wire 1696 (black) at driver side body wire
harness rear driver side scene light connector, terminal A and a known good ground.
.
If 22 to 28 VDC are not present, repair wire 1696 in lower driver side body
wire harness if repairable (TM 9-2320-325-14&P), or replace driver side
body wire harness (WP 0286).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION


Back to Top