TM-9-2320-328-13-P-1

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 1 OF 3

MARCH 2009

TM-9-2320-328-13-P-1 - Page 451 of 1318

TM 9-2320-328-13&P-1

0061-11

DRAFT

0061

HWT0516

WARNING

ICON 3

Remove rings, wristwatches, neck chains, and any other jewelry before working

around vehicle.

Jewelry can catch on equipment and cause serious injury.

Jewelry

and tools may short across electrical circuits and cause damage to equipment, or

severe burns or electrical shock to personnel.

Step 14.

Connect air lines at foam flush valve.

Disconnect pump house wire harness foam flush

control valve connector.

Put pump operator’s panel FOAM FLUSH switch to ON

position (WP 0004).

With a test lead set, check for 22 to 28 VDC between pump house

wire harness wire 2849 (yellow) at pump house wire harness foam flush control valve

connector, terminal 1 and a known good ground.

If 22 to 28 VDC are not present, go to Step 16.

Step 15.

Put FOAM FLUSH switch to OFF position (WP 0004).

Pull battery disconnect switch to

off position (WP 0007).

With a test lead set, check for continuity across wire 2200

(black) from pump house wire harness foam flush control valve connector, terminal 2 to

a known good ground.

a.

If there is continuity, replace foam flush control valve (WP 0271).

b.

If there is no continuity, repair wire 2200 in pump house wire harness if

repairable (TM 9-2320-325-14&P), or replace pump house wire

harness (WP 0302).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION