TM-9-2320-328-13-P-2

HEMTT-BASED WATER TENDER (HEWATT)

TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3

MARCH 2009

TM-9-2320-328-13-P-2 - Page 194 of 1390

TM 9-2320-328-13&P-2

0124-2

DRAFT

0124

HWT1698

NOTE

Make sure that mounting adapter indicator lamp is turned fully left (counterclockwise)

before Step 1.

Step 1.

Push battery disconnect switch to on position (WP 0007). Put mounting adapter CB1

switch to ON position (TM 9-2320-422-10).

Check if mounting adapter indicator light

illuminates.

If indicator light does not illuminate, go to Step 3.

NOTE

Mounting adapter indicator light will blink for approximately 3 seconds, then stay

illuminated if mounting adapter is operating properly.

Step 2.

Put mounting adapter CB1 switch to OFF, then back to ON position

(TM 9-2320-422-10).

Check if mounting adapter indicator continues to blink after

3 seconds.

a.

If mounting adapter indicator light continues to blink after 3 seconds,

notify Supervisor.

b.

If mounting adapter indicator light illuminates and stays continuously

illuminated after 3 seconds, go to Step 7.

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION