TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 55 of 1390
TM 9-2320-328-13&P-2
0115-5
DRAFT
0115
HWT1648
WARNING
ICON 3
110 Volt AC power is potentially lethal.
Do not work
on AC wiring when it is
connected to a power source.
Failure to comply may cause injury or death to
personnel.
NOTE
SHORELINE INLET receptacle plunger must be fully engaged for continuity to be
observed for Step 6.
Step 6.
Remove pump house panel B (WP 0339).
Disconnect shoreline inlet power cord from
SHORELINE INLET receptacle and 110 VAC power source (WP 0030). Disconnect 24-
volt battery charger power cord from 120-volt receptacle. With a test lead set, check for
continuity across shoreline power cord hot wire, from SHORELINE INLET receptacle
hot terminal to 120-volt receptacle hot terminal. Continue continuity check across
common wire and ground wire.
If there is continuity at all wires, go to Step 9.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
