TM-9-2320-328-13-P-2
HEMTT-BASED WATER TENDER (HEWATT)
TECHNICAL MANUAL; OPERATOR’S AND FIELD LEVEL MAINTENANCE MANUAL (INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST); PART 2 OF 3
MARCH 2009
TM-9-2320-328-13-P-2 - Page 63 of 1390
TM 9-2320-328-13&P-2
0116-3
DRAFT
0116
Change 1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
HWT3176
.
Step 6.
Remove driver side rear light bezel cover (WP 0335).
Disconnect driver side body wire
harness clearance light connector.
With a test lead set, check for 22 to 28 VDC
between wire 1606 (green) at lower driver side body wire harness clearance light
connector, terminals and a known good ground.
.
If 22 to 28 VDC are not present, repair wire 1606 in lower driver side body
wire harness if repairable (TM 9-2320-325-14&P), or replace driver side
body wire harness (WP 0286).
.
Step 7.
Turn Off Clearance Lamps (TM 9-2320-422-10).
Turn Service Drive Lights Off
(TM 9-2320-422-10).
Pull battery disconnect switch to off position (WP 0007).
With a
test lead set, check for continuity across wire 2640 (black) from driver side body wire
harness clearance light connector, terminals to a known good ground.
.
a.
If there is continuity, replace non-operating clearance light (WP 0229).
.
b.
If there is no continuity, repair wire 2640 in lower driver side body wire
harness if repairable (TM 9-2320-325-14&P), or replace driver side
body wire harness (WP 0286).
.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Back to Top
